NBN Fibre to the Premises (FTTP) installation guide

nbn™ Fibre to the Premises explained (FTTP)

All types of nbn™network connections that utilise a physical line running to the premises are considered fixed line connections. An nbn™ Fibre to the Premises connection (FTTP) is used in circumstances where an optic fibre line will be run from the nearest available fibre node, to your premises. FTTP also requires an nbn™ network device to be installed inside your home. This device requires power to operate and can only be installed by an approved nbn™ Installer or service provider.

What does the nbn™ Fibre (FTTP) equipment look like?

FTTP_NTD_Install.png

The Power Supply with Battery Backup is not required in many cases therefore your nbn™ Connection Box may directly connect to the power point.

AveoConnect will supply a gateway (router) and Ethernet cable to connect your internet and phone devices as required.

nbn™ Fibre to the Premises installation guide

attention.png  DO NOT CONNECT/DISCONNECT CABLES UNLESS DIRECTED TO DO SO BY AVEOCONNECT.
Access to the NBN Connection Box may be restricted. Call-out fees applied for tampered equipment.

Once your NBN connection box has been installed and/or activated by the NBN, AveoConnect will arrange the installation of the AveoConnect equipment. The AveoConnect Home Gateway will connect to a UNI-D port (C) designated by AveoConnect. AveoConnect does not use the UNI-V ports (D) for any services.

Removing_the_NBN_FTTP_connection_box_cover.JPG

The bottom of your nbn™ connection box (inside the cover that is mounted to the wall) will have a row of ports that look like this:

Plugging_into_the_NBN_FTTP_connection_box.JPG

Have more questions? Submit a request

0 Comments

Article is closed for comments.